Category: Client Profiles

  • 8’x12′ Reclaimed Cedar Shed Built Around Reclaimed Doors

    8’x12′ Reclaimed Cedar Shed Built Around Reclaimed Doors

    A modern shed designed around reclaimed doors

    A West Vancouver homeowner had a set of custom doors left over from a house renovation and didn’t want to waste them. Instead of fitting a standard door into a standard shed, the building was designed the other way around: the doors came first and the shed was built around them.

    SPECIFICATIONS:
    Size 8′ x 12′ (96 sq/ft)
    Design Modular utility shed
    Siding Reclaimed cedar, open-joint
    Roof Single-slope shed roof, corrugated Galvalume
    Windows Clerestory windows
    Doors Reclaimed French doors
    Permit status Under 10 m²: no building permit in most BC cities. Zoning still applies.
    Location West Vancouver, BC

    The result is a modern utility shed with a flat, single-slope roof, horizontal reclaimed cedar open-joint siding and a row of clerestory windows above the doors. The windows bring daylight into the space without giving up wall area for storage.

    Design details: reclaimed cedar, shed roof and clerestory windows

    The walls are clad in horizontal reclaimed cedar boards installed as open-joint siding, with a narrow, even gap between each board. The gaps create a strong shadow line across the wall and let moisture escape, while the warm reclaimed cedar tones stand out against the dark evergreens behind the shed. A horizontal cedar fence beside the building repeats the same pattern, so the shed looks like part of the landscaping rather than an add-on.

    The roof is a single-slope shed roof that rises toward the front, with a thin grey metal edge for a clean, modern profile. Below the roofline, a row of narrow clerestory windows in white trim runs across the top of the wall. Because they sit high, they bring in daylight and keep the wall space below free for shelves and storage. The reclaimed French doors, a stained wood frame with glass panes, are the focal point of the front wall and open onto a flat paved pad.

    Why reclaimed wood works on a Westcoast outbuilding

    Cedar holds up well in wet Westcoast weather, which makes reclaimed cedar a smart choice for a Westcoast outbuilding like this one. Open-joint siding lets the wall dry out between rain showers. The clerestory windows keep the shed bright for storage, a workshop or a small hobby space, and the clean lines suit a contemporary house.

    More photos and similar projects

    View the Photo Gallery, or browse more Backyard Outbuildings and Modular Laneway House Designs.

    Do you need a permit for an 8×12 shed?

    At 96 sq/ft, this size sits under the 10 m² (about 107 sq/ft) threshold that many BC municipalities use for the building permit exemption. Zoning rules for setbacks, height and lot coverage still apply, and each city sets its own limits, so check with the local building department first. For more detail, see the guide to the Maximum Shed Size Without a Permit.

  • NEW 9’x12′ Lifestyle Backyard Office: North Vancouver

    NEW 9’x12′ Lifestyle Backyard Office: North Vancouver

    9′ x 12′ Lifestyle Backyard Office

     

    North Vancouver Backyard Office
    North Vancouver 9×12 Lifestyle Backyard Office

    Our aesthetically discerning client was looking to re-locate his office from a paid office space to his backyard. Looking for something a clean modern design he choose a 9×12 Lifestyle Office with Open-Joint Hardie Siding with sleek Easytrim Anodized Aluminum reveals.

    Read More

  • Comox Valley Modular Office

    Comox Valley Modular Office

    Comox Valley Modular Office:

    Here is one of our newest designs heading to the Comox Valley in September (pending permit). It’s our 10’x16′ Contemporary Building with a 4′ Covered Porch.

    This design has our new wrap around clerestory windows.

     

    Comox Valley Modular Office
    Comox Valley Modular Office

     

    Everyone of our buildings are made to our clients exact specifications. Choose your colours, door and window configurations, siding types, you name it you can customize it.

    This building will be built in our North Vancouver Factory and transported fully built via BC Ferries to the final destination in the Comox Valley.

    (more…)

  • 10′ x 8′ Prefab Craftsman Garden Shed

    10′ x 8′ Prefab Craftsman Garden Shed

    10′ x 8′ Prefab Craftsman Garden Shed

    Westcoast Outbuildings is please to showoff our most recent build a beautiful 10′ x 8′ Prefab Craftsman Garden Shed in Richmond BC.

    Prefab Craftsman Garden Shed
    10′ x 8′ Prefab Craftsman Garden Shed

     

    View the FULL Project Profile HERE

  • Too Much Time Spent Building? A Sneak Peek at Our 2013 Projects

    Too Much Time Spent Building? A Sneak Peek at Our 2013 Projects

    Too much time building, not enough time promoting?

    It’s a good problem to have, but we haven’t kept you in the loop on what we’ve been building. We went back through the projects we finished in 2013 and found that most of them never got photos on the site. We were too busy building to promote.

    We’re close to posting photo galleries for all 33 of our 2013 projects. Here’s a sneak peek at one of our favourites from the year.

    12×12 backyard workout room in West Vancouver

    We finished this one in the spring for a well-known Vancouver restaurateur. It’s a 12×12 modern prefab shed set up as a workout room, with a wrap-around Trex deck. And who can forget the outdoor shower?

    Outbuildings.ca-Backyard-Workout-Room
    12×12 backyard workout room in West Vancouver with sliding glass doors, clerestory windows and a large composite deck

    See the full photo gallery of this West Vancouver workout room.

    Tell us what you think in the comments below.

  • 8′ x 12′ West Vancouver Garden Shed

    8′ x 12′ West Vancouver Garden Shed

    West Vancouver Garden Shed: The Stealth Shed

    West Vancouver Garden Shed
    8′ x 12′ West Vancouver Garden Shed: The Stealth Shed

    Sometimes out of sight out of mind also applies to a West Vancouver Garden Shed. Out client wanted a beautiful prefab shed but they didn’t want it to stand out. They wanted it to blend in.

    (more…)

  • 8×13 Backyard Office in Lynn Valley, North Vancouver

    8×13 Backyard Office in Lynn Valley, North Vancouver

    An 8×13 backyard office in Lynn Valley, North Vancouver

    This custom-built 8′ x 13′ (about 105 sq/ft) backyard office sits in the Lynn Valley neighbourhood of North Vancouver. It was built in 2013 and stayed under the size limit where many BC cities don’t require a building permit. It’s a prefabricated backyard office: the floor, wall and roof panels were made in a shop and then assembled on site. The photos below follow the build from the shop floor to the finished office.

    SPECIFICATIONS:
    Size8′ x 13′ (105 sq/ft)
    DesignContemporary backyard office, single-slope shed roof
    SidingLP SmartSide
    CeilingPine T&G
    OverhangsFront 18″; sides and rear 6″
    Door36″ full-lite fiberglass door
    Windows24″ x 32″ slider and 42″ x 56″ slider, plus clerestory windows
    Electrical4 wall plugs, overhead lighting, exterior lighting
    Heat2500W forced air
    Permit statusNo building permit required. Zoning still applies.
    LocationLynn Valley, North Vancouver, BC

    Why this office was prefabricated in panels

    The office sits well back in the lot, far from the street. Delivering a finished building that far in would have needed a large crane, and the crane alone would have cost too much for a building this size. Instead, the floor, wall and roof panels were built and framed in the shop, then brought to the yard and assembled on site by hand.

    Panel building keeps most of the work in a dry, controlled shop, so the framing is square and accurate. On site, the crew only needs to prepare the base, set the floor, raise the walls and finish the roof. That also means less noise, less mess and less disruption in the yard. For a lot with tight or long access, prefabricated panels are often the most practical and affordable way to build a backyard office.

    The photos show how it went together. The floor frame and the wall frames were built first in the shop, and the roof panels were staged and ready. On site, the ground was prepared, the insulated floor went down, and the wall panels were raised one by one. Next came the roof framing with its row of clerestory openings, then the blue LP SmartSide siding, the windows and the door. Because the pieces were already built, the office went from an empty patch of yard to a finished building quickly.

    What a small backyard office can include

    At 105 sq/ft, this office is small but fully finished. The pine T&G ceiling and white walls keep the inside bright, and a row of clerestory windows lets daylight in without using up wall space. Four wall plugs, overhead lighting and 2500W forced-air heat make it a comfortable home office, guesthouse or private retreat. A 36″ full-lite fiberglass door brings in extra light, and two slider windows give fresh air and a view of the yard. Outside, the blue LP SmartSide siding, white trim and 18″ front overhang give a clean, modern look that suits a Westcoast outbuilding in a wooded yard.

    Inside, the white melamine walls are easy to wipe clean and reflect light, while the warm pine ceiling adds a natural contrast. A 42″ x 56″ slider and a 24″ x 32″ slider give cross-breezes and a view of the yard, and the full-lite door lets in even more daylight. The overhead and exterior lighting mean the office is usable after dark, and the exterior light makes the path to the door easier to see in winter.

    Size is the main trade-off. At 8′ x 13′, the office fits a desk, a chair, shelving and a small seating spot, but not much more. That’s often enough for a home office or a quiet place to work, and keeping it small is what helps it stay within the permit-free size. If you need more room, a larger building usually needs a building permit, so it’s worth deciding early which matters more.

    Do you need a permit for a backyard office under 10 m²?

    Many BC cities allow a small accessory building under 10 m² (about 107 sq/ft) without a building permit, as long as it meets zoning rules for setbacks, height and lot coverage. Each city sets its own rules, so check with the local building department first. Zoning rules still apply, and electrical work is a separate matter: an electrical permit is likely required for the wiring. See the guides to the Maximum Shed Size Without a Permit and North Vancouver Shed Regulations.

    FYI: what to plan for

    This office was prefabricated in panels and assembled on site, because a crane to deliver a finished building that far into the lot would have been too expensive. Site preparation, delivery and the electrical connection are usually extra. An electrical permit is likely required, and zoning rules for setbacks, height and lot coverage still apply.

    Photo gallery: from shop floor to finished office

    Costs for a project like this depend on site preparation, delivery and the electrical connection, which are usually extra. Shown with optional decking and a second window.

    Frequently asked questions

    How big is this backyard office?

    It measures 8 feet by 13 feet, which is about 105 sq/ft of floor space.

    Can a backyard office have power and heat?

    Yes. This one has four wall plugs, overhead and exterior lighting, and a 2500W forced-air heater. The electrical connection is usually an extra cost, and an electrical permit is likely required.

    Why was this backyard office built as panels?

    The building site is far back in the lot, and a crane long enough to deliver a finished building there would have been too expensive. Building the panels in the shop and assembling them on site avoided the crane and kept the cost down.

    What would you use a backyard office for?

    A home office, guesthouse, private retreat or tool shed all work. The size, siding, doors and windows can be chosen to suit the homeowner and the yard.

    More outbuildings to explore

    See the Full Photo Gallery for This Backyard Office, or browse more Backyard Outbuildings and Modular Laneway House Designs.

  • North Vancouver Storage Shed

    North Vancouver Storage Shed

    When we first got the call from this client we knew right away this would be an exciting project. 

    My client had a plethora of garden implements, bikes, children’s toys and lawn chairs and needed a Storage Shed for his Lynn Valley house.

    But not just any house, a house with a very distinct architect designed modern look and feel.

    One of the challenges with Modern Design and Construction as that typically there is very little storage space included. We needed to design and build a storage shed that would complement and not look out-of-place.

    North Vancouver Storage Shed
    7′ x 15′ Integrated North Vancouver Storage Shed

    (more…)