About this office
This small backyard office fits into the backyard of an urban townhouse in Richmond. At 8′ x 10′ (80 sq/ft), it’s just big enough for a desk and shelves, and small enough to fit a tight lot. A pair of full-glass French doors and a row of clerestory windows bring in plenty of light. With no room to drive in, the finished office was lifted over the fence by crane.
A backyard office for a small townhouse lot
Townhouse backyards are often small and closed in by fences and garages. This office was sized to fit the space: 8 feet deep and 10 feet wide. The front is dark grey Hardie panels with a small gap between each one, while the sides and back are clad in corrugated steel. From the lane, only the roofline and the high windows show above the fence.
A single-slope shed roof in standing seam metal reaches 18 inches past the front wall. Lights set into the soffit light up the doors at night.
Built in a factory, then craned into place
The office was built indoors in a factory, where the walls, windows, doors and finishes all went in before it left. It then travelled by trailer to Richmond. Because the lot had no side access, a crane truck lifted the office from the lane and set it down over the fence.
| Size | 8′ x 10′ (80 sq/ft) |
|---|---|
| Design | Modern backyard office with a single-slope shed roof |
| Build type | Factory-built modular (CSA A277) |
| Siding | Open-joint Hardie panels + corrugated steel |
| Roof | Standing seam metal |
| Overhangs | Front 18″; sides 12″ |
| Windows | Vinyl, with clerestory windows |
| Doors | 72″ full-glass French doors |
| Interior | Pine tongue-and-groove ceiling, drywall walls, vinyl plank floor |
| Power and heat | Yes |
| Porch and deck | Yes, a small wood deck at the doors |
| Permit status | Richmond’s permit exemption is for storage sheds with no mechanical services. Check with the City for a heated office. |
| Location | Richmond, BC |
More photos
The photos below show the finished office, the views from the lane, the crane lift and the build in the factory.
What to plan before building a backyard office in Richmond
- Size: 8′ x 10′ (80 sq/ft) fits a desk, a chair and some shelving, and it’s small enough for a townhouse yard.
- Permit: Richmond only skips the building permit for one storage shed under 10 m² with no mechanical services. An office with heat or other services should be checked with the City first.
- Location: Richmond keeps accessory buildings in the rear yard and sets side and rear setbacks. Check them before choosing a spot.
- Access: if there’s no side access, plan for a crane lift from the lane or street. The crane needs room to set up.
- Light: full-glass French doors and clerestory windows keep a small office bright.
Frequently asked questions
How big is this backyard office?
It’s 8 feet by 10 feet, which is 80 sq/ft (about 7.4 m²) of floor space.
Do you need a permit for a backyard office in Richmond?
Richmond doesn’t require a building permit for one storage building under 10 m² (108 sq/ft) with no mechanical services. A permit is needed at 10 m² or more, or if the building has operating mechanical equipment. Zoning still applies, and the building can’t be used as a dwelling. See Richmond Shed Regulations for the details.
How do you get a backyard office into a yard with no side access?
This one was lifted by a crane truck from the lane and set down over the fence. That’s common for factory-built buildings on small lots.
Can an office like this be built bigger?
Yes. For a slightly larger example, see the 8×13 backyard studio in Kerrisdale.
More outbuildings to explore
Browse more Backyard Outbuildings, check the Shed Rules by City, or read about the Maximum Shed Size Without a Permit.
